3.1 MINER IDENTIFICATION ON THE NETWORK

You will need to determine the IP address of the miner received from the router/modem.

• Run the utility WhatsMinerTool
• Press the button [ IP Monitor ] ①
• In the opened “Detect and Bind IP” window, click the button [ Start ] ②

• Press and hold the IP found button on the device panel until the green and red LEDs flash together several times.

At the same time, a line with our miner should appear in the Detect and Bind IP window.

• Pay attention to the Source IP column (for example, 192.168.88.96) - this address must be remembered.

• Close this window and confirm closing (press [Ok] in the pop-up question).

Now you need to add the network scan range of the utility WhatsMinerTool

• Press the button [ Miner IP ] ①

If there are already any entries in this window, you can delete them, modify them, or simply add new ones.

LET’S ADD A NEW ONE

• In the Start IP field ② enter the previously obtained IP address, changing the last digit to “1” (192.168.88.1).
• In the End IP field ③ enter the received IP address, changing the last digit to 255 (192.168.88.255)
• Press the button [ Add ] ④
• The entered range will be displayed in the list ⑤.

• Close the window or click [Ok] at the bottom of the window.

Now you can run a network scan.

• In the main utility window, click [ Start ] ①

In this case, the button will change its name to “Monitoring”, scanning will start and after a while the found devices will be displayed in the list.