BiXBiT firmware for ASIC Antminer T17

Custom firmware designed for Bitmain Antminer T17 works using AsicBoost technology and allows you to overclock ASICs up to 60 Th/s. Can be used with both immersion and air cooling.

  • AsicBoost
    Technology
  • Overclocking
    up to 60 Th/s
  • DevFee is
    just 2.8%
  • Embedded
    Antivirus
  • Automatic
    frequency tuning

What is special?

  • Allows to adjust the frequency and voltage of the chips for the Antminer T17 model.
  • Saves money on purchasing an additional power supply, increasing the computing power of the device by up to 40%.
  • Developer fee - 2.8%.

Installation manual

Important!

On the miner page, in the System>Overview>File System Version tab, check the date of the installed firmware.

  • Available firmware date is up to December 2019 (including): start from Step 1.
  • The date of the current firmware is older than January 2020 inclusive: go directly to Steps 2 and 3.
  • Installed firmware version up to December 2019 (inclusive):

    Download the UNLOCK SSH file, then unzip it.

    Using notepad or another editor, make changes to the settings.cfg file:

    Change the IPNETWORK value to your current IP-address. For example, if the IP-address of your device is 190.175.100.*, you should write IPNETWORK=190.175.100;

    Use the IPSTART and IPEND parameters to adjust the search range. For example, if your device has a range from 190.175.100.5 to 190.175.100.35, then you need to write: IPSTART=5 IPEND=35;

    In the ASICWEBPASS parameter you must enter the password that is relevant for your Antminer web interface. That is ASICWEBPASS=your_password. If you didn't set a password, the default value is root;

    For SSH ASICSSHPASS also enter the password in the format SSH ASICSSHPASS=your_password. If you didn’t set this parameter, the default is admin;

    Don't forget to save the new file.

    To scan the network and unlock SSH, run the 1.unlock_ssh.bat script. The process may take 2-5 minutes.

    To unlock SSH permanently, run the 2.replace.bat script.

    Download and install firmware for T17.

  • Installed firmware version is January 2020 (or later):

    Download image for the T17 version.

    Format your SD card with the FAT32.

    Unzip the files and then transfer them to the SD card.

    Repeating the steps from the video below, prepare the ASIC for firmware installation:



    Download the BiXBiT firmware for T17 and move to step 3.

  • Installing BiXBiT Firmware for Bitmain T17:

    On the tab System>Upgrade, click Browse and navigate to the previously downloaded firmware file.

    Select the firmware file then click Flash image.

    There will be appeared informing message that the AntMiner T17 firmware can be updated. Then the update will be started.

    When the firmware is updated, a message about successful installation will be appeared.

    Press Ctrl+F5 on your keyboard to reset the page cache.