All documents
Home Documentation Connecting an additional variable power supply unit 3.1 ASSEMBLING THE MODIFIED FEEDING RAIL OF THE MINER
Leave your email so you don't miss out!
By subscribing, you agree to our
Privacy Policy!

3.1 ASSEMBLING THE MODIFIED FEEDING RAIL OF THE MINER

  • Disconnect the fan terminal
  • Unscrew the screws  holding the module with the control board
  • Disconnect the power supply stub 

  • Remove the control board module, disconnect it completely if necessary by disconnecting the stub .
  • Unscrew screw  of the negative rail and replace it with a similar one, respecting the thickness of the additional terminal
  • Unscrew the screws of the feeding rail and remove it.

 

  • Modify the rail by removing the shaded area , or prepare a similar one from a copper plate:

Use only the modified rail of the miner! It is necessary to avoid short-circuiting the positive terminal of the additional power supply with the feeding rail of the main power supply! Otherwise the devices and power supply units can be damaged!

 

  • Put the modified rail in place and screw it down with the screws . The contacts of the first board ② must remain empty in this case.